扫雷红包群规则大全

Tel: +8613053736800
Categories
Contact Us
Tel: +8613053736800
Mob: +8613181342339
Email: maksim@sdtradestar.com
Add: ​North Workshop Jidian 1 Road, High-tech Zone, Jining, Shandong
News
Home > News > Content
Diagnosis And Treatment Of High Engine Idle Speed
Sep 20, 2019

The engine idling speed is too high. When the throttle is raised, the engine speed is still higher than the idling speed.

⑴cause

① the throttle lever is not adjusted properly.

② the throttle return spring is too soft.

③ the idle limit stop or adjustment screw is out of adjustment.

扫雷红包群规则大全④ the idle spring is too hard or the pre-tension is adjusted too much.

扫雷红包群规则大全⑵diagnosis and treatment

扫雷红包群规则大全excessive idle speed is one of the easiest to check and troubleshoot. first check whether the throttle is back to the minimum position. if it is not in place, check the throttle adjustment and throttle return. adjust the throttle cable limit screw. if the throttle still cannot return, check whether the throttle return spring is too soft. if it is the fuel injection pump shortly after overhauling, you should consider whether the idle speed adjustment is correct, whether the idle spring pre-tension adjustment is too large, and if the spring has been replaced, check whether the spring is too hard.

unstable idling

the manifestation of the engine idling instability is that when the vehicle is idling, it may flicker, or there may be vibrations, which cause the car to stall during a sudden deceleration or gear shift.

⑴cause

扫雷红包群规则大全① there is air in the oil circuit.

扫雷红包群规则大全② the oil supply to the low-pressure oil circuit is not smooth.

扫雷红包群规则大全③ improper adjustment of idle speed stabilizer.

④ poor atomization of the injector.

⑤ the fuel supply of the fuel injection pump is uneven.

扫雷红包群规则大全⑥ the pins and forks of the connecting rods of the governor are too worn.

扫雷红包群规则大全⑵diagnosis and treatment

扫雷红包群规则大全when diagnosing idling instability, it should be analyzed and judged according to the length of engine use time and the degree of maintenance of the engine.

① first, check whether the oil supply to the low-pressure oil circuit is unobstructed.

_ whether the filled diesel meets the requirements and whether the maintenance of the car engine is timely, otherwise it should be cleaned or maintained and replaced.

② if the car is stopped for a long period of time or the fuel tank oil is not replenished in time, a small amount of air penetrates into the oil passage, and exhaust treatment should be performed.

③ if the car has been used for a long time, the fuel injection pump has also been debugged several times without checking the governor's wear. during the commissioning, pay attention to inspect the joints of the governor and throttle lever for excessive wear. otherwise, it should be replaced or repaired. when welding and repairing rotating parts, attention should be paid to the symmetry of quality to ensure balance.

扫雷红包群规则大全④ unsteady idling and vibration are caused by the uneven supply of fuel by the injection pump, which can be checked by the cylinder-by-cylinder oil cut method. if the broken cylinder does not cause a change in rotational speed, it means that the cylinder is insufficiently fueled or that the injector is poorly atomized. the fuel injector should be checked before the fuel injection pump.

⑤ if the idling stability device is not adjusted properly, it should be repaired on the test bench again.

16

previous: no information

Next: Cummins Engine Parts Identification Method

  • Contact Us
    Tel: +8613053736800
    Mob: +8613181342339
    Email: maksim@sdtradestar.com
    Add: ​North Workshop Jidian 1 Road, High-tech Zone, Jining, Shandong
  • Categories
  • Copyright © Shandong Joint-Winning Construction Machinery Co., Ltd. All Rights Reserved.
    扫雷10至30元15倍群规图 20到100扫雷群规怎么写 微信群公告规则扫雷 扫雷怎么开群 微信扫雷群规图片